Browse categories
Explore
Fiverr Pro
English
$
USD
I will design bms pcb lithium battery battery management system schematic and layout
Expert PCB Layout, Schematic and Gerber Design
Hi, I’m Alexander, an electronics and embedded hardware designer specializing in custom PCB and IoT development. I design ESP32 and STM32 boards, circuit schematics, multilayer PCB layouts, WiFi/Bluet...
About this Gig
Looking for a safe, reliable, and production-ready BMS PCB for your lithium battery pack?
I specialize in BMS schematic design and PCB layout for Li-ion, LiPo, and LiFePO4 battery systemsfrom simple 1S protection boards to advanced multi-cell BMS designs up to 16S+.
What I provide:
- Custom BMS schematic design
- Passive or active cell balancing
- Overcharge, over-discharge & overcurrent protection
- Short-circuit & temperature protection
- MOSFET charge/discharge control
- Fuel gauge & battery monitoring IC integration
- I2C, UART, SMBus & CAN communication
- 26 layer PCB layout with high-current routing
- BOM, Gerber, schematic PDF & source files
- ERC/DRC and DFM checks
Ideal for:
- E-bikes
- E-scooters
- Drones
- Robotics
- Solar Storage
- Power Banks
- EV Battery
- Packs
- Portable Electronics
Tools:
- Altium Designer
- KiCad
- EAGLE
I follow practical PCB design and battery protection principles to create manufacturing-ready BMS designs tailored to your voltage, current, cell count, and application.
Message me with your battery specifications before ordering.
FAQ
What type of batteries can you design a BMS for?
I design BMS PCBs for Li-ion, LiPo, and LiFePO4 battery packs from 1S to 16S+.
Can you design both the schematic and PCB layout?
Yes. I can provide the complete BMS schematic, PCB layout, BOM, Gerber files, and source files.
Do you support cell balancing?
Yes. I can implement passive or active cell balancing based on your requirements.
Can you add communication interfaces?
Yes. I can integrate I2C, UART, SMBus, or CAN where required.
Can you work with an existing BMS schematic?
Yes. I can review, modify, troubleshoot, and optimize your existing design.
Which software do you use?
I primarily use KiCad, Altium Designer, and EAGLE.
