I will develop stm32 firmware in embedded c using stm32cubeide hal and freertos
Embedded Firmware Engineer, STM32, ESP32, nRF52, Linux, AOSP
Level 1
Has met certain performance criteria and shows strong potential in the marketplace.
About this Gig
Need STM32 firmware that works first time on real hardware? I develop production-grade embedded C firmware for the whole STM32 family (F0, F1, F4, G0, G4, H7, L4, U5, WB) using STM32CubeIDE, HAL and LL drivers.
What I deliver:
Peripheral drivers: UART, SPI, I2C, ADC, DAC, PWM, timers, DMA, GPIO
Sensors and modules: IMU, GPS, displays, SD card
FreeRTOS multitasking firmware with queues, semaphores and timers
Communication: CAN bus, USB CDC/HID, Modbus RTU, BLE, Ethernet, MQTT
Motor control: PWM, encoders, PID, BLDC and stepper drivers
Low power design and battery life optimization
Bootloaders and firmware update (UART, USB DFU, OTA)
Debugging and bug fixing of existing STM32 projects
Porting from Arduino, PIC or AVR to STM32
Every order includes clean, commented source code, a STM32CubeIDE project that builds immediately, and a short document covering architecture and flashing.
Why work with me:
Commercial embedded systems experience, not hobby projects
Tested on real Nucleo, Discovery or custom boards before delivery
Message me with your MCU, board and requirements before ordering and I will confirm scope and delivery time.
My Portfolio
FAQ
Which STM32 series do you support?
All Cortex-M STM32 parts: F0, F1, F2, F3, F4, F7, G0, G4, H7, L0, L4, L5, U5, WB and WL. STM32MP1 Cortex-M4 cores on request.
Do I get the source code?
Yes. Every package includes the full STM32CubeIDE project, the .ioc file and all source. You own the code.
Can you fix or extend my existing STM32 code?
Yes. Send the project and describe the problem. Most fixes fit the Basic package, larger changes the Standard.
Do you need my hardware?
Usually not. I test on Nucleo and Discovery boards. For a custom PCB, send the schematic. Shipping a board helps on complex projects.
HAL, LL or bare metal registers?
Whichever suits the job. HAL for fast development, LL or registers for small code size and tight timing.
Do you also design the PCB?
Yes. I can design the schematic and PCB layout for your STM32 board and deliver it together with the firmware. Message me with your requirements and I will quote the hardware part as a custom offer or gig extra.
What do you need to start?
MCU part number or board, a description of the required behaviour, schematic or pinout, datasheets of attached modules and any existing code.

