Browse categories
Explore
Fiverr Pro
English
$
USD
I will design custom ev bms battery management system and pcb
Embedded Systems, PCB Design Engineer, RF, IoT, Hardware
I’m an Embedded Systems and Electronics Engineer focused on developing custom hardware, PCB and embedded solutions for real-world products.
I work across RF hardware, embedded systems, power electron...
About this Gig
Need a custom EV Battery Management System engineered around your battery packnot another generic BMS PCB?
I design custom BMS hardware and battery-management electronics for EVs, e-mobility products, robotics, marine systems, energy storage and advanced lithium battery applications.
This service is built for product developers who need more than a basic protection board.
I can engineer the BMS architecture around your actual battery requirements, including cell monitoring, balancing, voltage/current measurement, temperature sensing, protection, power management, CAN communication and production-oriented PCB design.
WHAT I CAN ENGINEER
EV battery management systems
Lithium-ion BMS
LiFePO4 BMS
Smart BMS hardware
Multi-cell battery packs
High-voltage BMS architecture
Cell monitoring and balancing
Voltage/current sensing
Temperature monitoring
Over-voltage / under-voltage protection
Over-current and short-circuit protection
Charge/discharge control
CAN communication AND MORE....
Please contact me before placing an order so I can review your battery specifications and recommend the appropriate package.
Other Electronics Engineering Services I Offer
FAQ
Can you design Li-ion and LiFePO4 BMS systems?
Yes. The BMS architecture can be developed around the selected battery chemistry and its electrical requirements.
Can you design a high-voltage BMS?
Yes, high-voltage BMS projects can be handled as custom engineering projects. Please provide the pack voltage, cell count, current requirements and isolation requirements before ordering.
Can you add CAN communication?
Yes. CAN communication can be integrated into the BMS hardware where required. CAN/CAN FD requirements should be specified during project scoping.
Can you design the BMS firmware too?
Firmware can be provided as a separate custom service depending on the MCU, BMS IC, communication protocol, SOC/SOH requirements and control logic.
