I will do canopen modbus rtu and rs485 industrial embedded firmware development
EMBEDDED SYSTEM AND IOT DEVELOPMENT
About this Gig
I develop reliable industrial embedded firmware for CANopen, Modbus RTU, and RS485 communication systems, supporting seamless data exchange between microcontrollers, PLCs, sensors, controllers, and industrial equipment.
What My Service Includes:
- CANopen protocol implementation and configuration
- Modbus RTU master and slave development
- RS485 serial communication setup
- UART, SPI, and CAN bus integration
- STM32, ESP32, AVR, and other MCU firmware
- Register mapping and data handling
- Device addressing and communication configuration
- Error detection, CRC checks, and fault handling
- Firmware debugging and protocol testing
What You Will Receive:
- Functional embedded firmware source code
- Protocol configuration and implementation
- Tested communication routines
- Clear code documentation
- Hardware integration guidance
- Debugging support and technical notes
Let's discuss your controller, communication protocol, and hardware specifications. Send me a message to get your CANopen, Modbus RTU, or RS485 firmware project started!
Platform:
ESP32
Expertise:
Firmware development
•
Microcontrollers
•
Networking
Other Electronics Engineering Services I Offer
FAQ
Can you integrate CANopen and Modbus RTU on the same microcontroller without communication conflicts?
Yes. I can implement both protocols with proper task scheduling, interface configuration, and communication handling based on your hardware architecture.
Can you work with an existing firmware project that has unstable RS485 communication?
Yes. I can inspect existing code, identify communication faults, correct timing issues, and improve data transmission reliability.
. Can you configure custom Modbus registers to match my PLC's existing address map?
Yes. I can configure holding registers, input registers, coils, discrete inputs, function codes, and device addressing to match your PLC requirements.
How will you handle CANopen communication errors, node failures, and bus interruptions?
I can implement error monitoring, heartbeat supervision, node guarding, emergency messages, and recovery routines where supported by the target hardware.
Can you develop firmware before my physical PCB or industrial controller is ready?
Yes. Development can begin using your MCU details, schematic, pin assignments, protocol specifications, and available simulation or testing environment.

