I will design rf power amplifier, microwave, analog circuit, rf audio pcb, simulate cst
rf pcb engineering, hardware design, embedded system firmware development
About this Gig
Hello,
I'm an RF PCB & Hardware Engineer specializing in RF power amplifiers, microwave circuits, analog electronics, RF audio PCB design, and high-frequency circuit simulation. I can take your project from concept and circuit design through simulation, optimization, PCB development, and prototype ready deliverables.
DESIGN SERVICES I OFFER
- RF Power Amplifier
- Microwave Circuit
- RF & Analog Circuit
- RF Audio PCB
- RF PCB Layout & Hardware
- Matching Networks & Impedance Matching
- Filters, Oscillators & RF Front-End Circuits
- High-Frequency Circuit Simulation
- Gain, S-Parameter, VSWR & Performance Analysis
- Circuit Optimization & Prototype Support
SOFTWARE I USE
CST Studio Suite | Keysight ADS | Ansys HFSS | AWR Microwave Office | Altium Designer | KiCad | LTspice | MATLAB
DELIVERABLES
- Professional circuit schematics
- RF/PCB design files
- CST/ADS/HFSS simulation models
- Simulation results and performance analysis
- Optimized circuit parameters
- PCB layout and manufacturing files
- BOM/component recommendations
- Design documentation/report
- Source/editable files
- Prototype ready engineering support
Message me today with your requirements and lets get started!
FAQ
1. What RF and electronic circuits can you design?
I can design RF power amplifiers, microwave circuits, analog circuits, RF audio PCBs, matching networks, filters, oscillators, RF front-end circuits, and other high-frequency electronic systems.
2. Can you simulate and optimize my RF circuit?
Yes. I can simulate and optimize your design using CST Studio Suite, ADS, HFSS, and AWR, including performance analysis such as gain, S-parameters, VSWR, impedance matching, and frequency response.
3. Can you design the PCB after completing the circuit?
Yes. I can take the project from concept and schematic to RF PCB layout and prototype-ready manufacturing files, depending on your project requirements.
4. What files will I receive?
Depending on your package, you can receive schematics, PCB files, simulation models, simulation results, optimized parameters, BOM, manufacturing files, reports, and editable source files.
5. Can you work with my existing design?
Absolutely. I can review, troubleshoot, simulate, optimize, redesign, or improve an existing RF/analog/PCB design. Send me your schematic, specifications, or project requirements before ordering so we can determine the best approach.
