I will design can fd automotive ecu pcb stm32 high speed communication hardware

Hello, Welcome!!

Need a CAN FD automotive ECU PCB for a vehicle-control or embedded project? I design CAN FD hardware around your MCU, transceiver, I/O, power needs, and board constraints, using your schematic or project brief.

What I Offer

• CAN FD ECU PCB schematic and layout
• CAN FD controller and transceiver interfaces
• STM32-based CAN FD hardware
• CAN FD termination and protection circuits
• Automotive connectors and harness interfaces
• ECU power input, filtering, and reverse-polarity protection
• Sensor and actuator I/O integration
• CAN FD node and gateway interface hardware
• MCU clock, reset, debug, and programming headers
• 2-layer or 4-layer PCB layout
• Component selection, footprint checks, and BOM
• ERC/DRC checks and DFM review
• Gerbers, editable source, and 3D/STEP when applicable

I can work from a schematic, block diagram, datasheets, reference design, or clear requirements. PCB design and manufacturing files are included as agreed; firmware, fabrication, and vehicle certification are not included unless agreed separately. 

Message me with your requirements before ordering.