Browse categories
Explore
Fiverr Pro
English
$
USD
I will design pcb layout pcb routing rf nrf52840 ip5356 eagle routing altium designer
PCB Design, Embedded System, IOT and Firmware Development
Hello and Welcome to my profile, My name is Enitan, i am an Electronics Engineer with expertise in PCB design, embedded systems, and IoT development. I design high-performance circuits, firmware, and ...
About this Gig
PCB Routing & Layout Design in Autodesk Eagle
Hello and Welcome!!
Transform your schematic into a professionally routed PCB with optimized layout, clean routing and manufacturing ready deliverables.
Whether you're developing an ESP32 device, nRF52840 BLE product, battery-powered wearable, IoT sensor, RF system, or embedded hardware project, proper PCB routing is essential for performance, reliability and manufacturability.
I specialize in PCB layout and routing using Autodesk Eagle, creating optimized designs with attention to signal integrity, power distribution, RF performance and manufacturing requirements.
What I Will Provide:
- Autodesk Eagle Design Files
- nRF52840 PCB Layout
- ESP32 PCB Layout
- Battery Charger Circuit Layout (IP5356)
- RF and Antenna Layout Considerations
- Design Rule Check (DRC)
Why Choose Me?
- Professional PCB Design Experience
- Clean and Organized Layouts
- Optimized Routing Techniques
- Manufacturing Ready Deliverables
- Attention to Signal Integrity and Power Design
Ready to turn your schematic into a production ready PCB? Message now and let's bring your hardware project to life.
Other Electronics Engineering Services I Offer
FAQ
Can you route an existing schematic?
Yes. I can convert your completed schematic into a fully routed PCB layout.
Do you work with ESP32 and nRF52840 designs?
Yes. I have experience with ESP32, nRF52 series, and IoT hardware layouts.
Can you design RF and antenna sections?
Yes. RF routing and antenna placement can be included where required.
Do you support battery-powered devices?
Yes. I can design layouts for battery-powered and low-power products.
Will I receive Gerber files?
Yes. Manufacturing-ready Gerber files will be provided.
Can you optimize an existing PCB layout?
Yes. I can review and improve routing, placement, and signal integrity.
What software do you use?
Primarily Autodesk Eagle, depending on project requirements.
