Browse categories
English
$
USD
Connect to your AI
I will design buck converter, boost converter, and buck boost power electronic pcb
Power Electronics and PCB Design Specialist
Hi, I’m Eric Donald, a PCB designer focused on power electronics and solar energy hardware. I design MPPT controllers, solar chargers and off grid solar boards, along with buck, boost and buck boost c...
About this Gig
Gig Description:
Need a buck, boost or buck-boost converter PCB that runs cool, stays stable and works on the first build? I design efficient, production-ready converter boards for startups, investors, engineers, and product teams.
WHAT I WORK ON:
- Buck converter PCB
- Boost converter PCB
- Buck-boost converter PCB
- DC-DC converter design
- Step-down regulator PCB
- Step-up regulator PCB
- Synchronous buck converter
- High-current converter PCB
- Wide input voltage converter
- Battery powered converter
- Power PCB
- LED driver PCB
- Solar MPPT converter board
- Switching regulator PCB
- Power module PCB
- Existing converter redesign
WHAT YOU WILL RECEIVE:
- Clean schematic
- Optimized PCB layout
- Gerber files
- BOM with component selection
- Pick and place file
- Design documentation
- Source design files
WHY CHOOSE THIS GIG:
- Thermal and EMI aware layout
- Low noise, high efficiency design
- Correct trace and copper sizing
- Short switching loops
- Protection built in
- Fast delivery
- Clear communication
- Manufacturing-ready results
Send your voltage, current, and board size before ordering, and I will reply with a clear plan. Let us build your converter PCB today.
FAQ
What details do you need to start?
Send your input voltage range, output voltage, maximum current and board size limit. If you have a preferred switching frequency or a reference design, send that too.
Should I choose a buck, boost or buck-boost converter?
A buck steps voltage down, a boost steps it up, and a buck-boost is for when your input can sit above or below the output. Tell me your requirements and I will recommend the right one.
Can you design converters for high current?
Yes. I size traces and copper pours for your current, keep switching loops short and plan heat flow so the board stays cool and stable under load.
Will the files be ready for manufacturing?
Yes. You receive Gerber files, BOM, pick and place file, schematic and documentation, so you can send the board straight to a fabrication house.
Can you improve a converter board I already have?
Yes. Send your schematic or board files and I will check them for heat, noise and efficiency problems, then fix the layout or rebuild the design.
