Browse categories
Explore
Fiverr Pro
English
$
USD
I will design custom ardupilot flight controllers rc transmitters load cells rigid flex
About this Gig
About this gig
I specialize in end to end electronic design, schematic capture, and PCB layout for drone avionics, RF transmitters, precision strain gauge amplification systems, and compact rigid flex hardware. Whether you need an STM32 based ArduPilot autopilot or an industrial weighing cell interface, I deliver manufacturing ready Gerber files, BOMs, and 3D models.
Hardware Design & Engineering Services:
- Custom ArduPilot Flight Controller Layout
- Drone Power Distribution Boards (PDB)
- Quadcopter UAV Electronics
- Drone RC Transmitter Circuitry
- Telemetry & Wireless Communication Modules
- Load Cell Signal Conditioning
- Industrial Weighing Cell Interfaces
- Wearable Bioimpedance & Biosensor PCBs
- Autonomous Robot (AGV/AMR) Controllers
- Multilayer Rigid Flex PCB Layout
- High Speed Signal Integrity & Impedance Control
- Full Gerber & Manufacturing Output Generation
- Multi EDA Schematic Capture
- Bill of Materials (BOM) Optimization
- 3D CAD Integration & Assembly Files
What Youll Get
- Custom UAV/Drone PCB tailored to your system requirements
- Flight controller, PDB, telemetry, GNSS, and sensor integration
- STM32, CAN Bus, UART, SPI, I²C, and other interface support
message me now to get started
Other Electronics Engineering Services I Offer
FAQ
What type of UAV electronics can you work on?
Flight controllers, PDBs, telemetry boards, GNSS interfaces, RC electronics, sensor boards, and custom drone PCBs.
Can you work with STM32 based flight controllers?
Yes. I can develop PCB hardware around STM32 F4, F7, and H7 platforms with common UAV sensors and interfaces.
Can you integrate CAN Bus and other communication interfaces?
Yes. CAN/CAN-FD, UART, SPI, I²C, RS485, Ethernet, and other required interfaces can be incorporated
Do you handle RF and telemetry PCB layouts?
Yes. RF modules, antenna interfaces, controlled-impedance routing, and telemetry circuitry can be included.
What files will I receive?
Depending on the package, deliverables can include schematics, PCB source files, BOM, Gerbers, NC Drill, Pick & Place, and 3D STEP files.
Can you work from an existing drone PCB or schematic?
Yes. I can review, modify, redesign, or improve existing UAV electronics based on your requirements.
What do you need to start?
Send your project requirements, existing files if available, target components, board dimensions, interfaces, and manufacturing requirements.
