I will develop ti mmwave radar solutions for tracking and detection
About this Gig
Are you looking for professional RF, microwave, antenna, or radar PCB development for your electronic project?
I provide specialized RF and microwave PCB engineering services focused on high-frequency performance, impedance control, signal integrity, and reliable manufacturing.
My services include:
- RF and microwave PCB layout
- High-frequency multilayer PCB routing
- RF transmitter and receiver circuits
- Radar sensor PCB development
- FMCW radar circuit layouts
- RF power amplifier and low-noise amplifier PCBs
- Microstrip patch antenna layouts
- UWB, GPS and LoRa antenna integration
- RF filters, mixers and power dividers
- 50-ohm impedance-controlled routing
- Antenna matching and RF circuit integration
- PCB schematic development
- BOM, Gerber and manufacturing files
- PCB design rule checking (DRC)
I work with professional PCB development tools to create organized, efficient, and manufacturing-ready electronic solutions based on your project specifications.
Whether you need an RF communication board, microwave circuit, antenna PCB, or radar sensor hardware, I can help develop your project from schematic to PCB layout.
Contact me before placing an order to discuss your technical requirements.
File format:
STEP
•
SCH
•
•
Circ
•
PDSPrj
Software:
Allegro
•
EasyEDA
•
LabVIEW
•
Matlab
Interface:
MIPI DSI/CSI
•
I2S
•
SPI
•
SDIO
•
PCIe
•
BT
•
GSM/GPRS
•
LTE
FAQ
Can you develop high-frequency RF PCBs?
Yes. I can create high-frequency PCB layouts with controlled impedance, appropriate stackups and RF routing techniques based on your specifications.
What types of RF and radar PCBs do you develop?
I work on RF transmitters, receivers, radar sensors, microwave circuits, RF amplifiers, antenna boards and wireless communication hardware.
Which PCB software do you use?
I can work with professional PCB development workflows, including Altium Designer and KiCad, depending on the project requirements.
Can you develop multilayer RF PCBs?
Yes. I can work on multilayer RF PCB layouts with suitable stackup and routing requirements.
Can you work with existing RF circuit designs?
Yes. You can send your existing schematic, PCB files or reference design for review and further development.

