Browse categories
English
$
USD
Connect to your AI
I will design a custom esp32 p4 camera pcb board with mipi csi2 and lte multilayer pcb
Mechatronics Engineering Expert
Hi, I’m Engineer Deji, a Certified Mechatronics Engineer with 4+ years of hands-on experience delivering high-performance electronic, robotics and sensors-related cases solutions. I specialize in PCB ...
About this Gig
Do you need a custom ESP32-P4 board that captures images and sends them over 4G LTE? I design the complete hardware, from schematic to manufacturing-ready files.
WHAT I DESIGN
- ESP32-P4 core: power, flash/PSRAM, clock, boot/reset
- MIPI CSI-2 camera interface (100 Ω controlled-impedance routing, length matching)
- LTE modem (SIM7600 / A7670 / SIM7670 class) with SIM, antenna and ESD protection
- Power architecture sized for modem peak current (~2 A on SIM7600G)
- ESP32-C6 for Wi-Fi/Bluetooth (the P4 has no built-in radio)
- Optional sensors: IMU, temperature, humidity, pressure, microphone, GNSS
WHY BUYERS CHOOSE THIS
Modem and camera boards often fail from power droop and noise, not bad routing. I check power, grounding and RF before layout.
YOU RECEIVE
Editable Altium/KiCad/EasyEDA source, Gerbers, drill, BOM with part numbers, pick-and-place, stack-up/impedance notes, 3D model, DRC/ERC results.
OPTIONAL (Premium)
Assembled prototype, ESP32-P4 firmware bring-up, camera + LTE tests, shipping to you (fabrication and parts at cost).
Message me first with your camera sensor, LTE band/region and board size so I can confirm scope.

