Browse categories
Explore
Fiverr Pro
English
$
USD
I will draft home assistant multi sensor layouts and circuit sets
About this Gig
Tired of cluttered, messy multi-sensor enclosures in your smart automation workspace? Consolidating mmWave presence modules, environment loggers, and ambient meters into one compact system makes tracking a breeze.
I provide precision 2D circuit layout formatting and schematic capture for all-in-one smart automation multi-sensor clusters. I map your sensor modules into clean, layered footprints configured for compact, sleek project enclosures.
What this service handles:
Designing multi-layer schematic captures for complex tracking arrays
Separating sensitive sensor pads from local power bus paths graphically
Mapping compact component placements optimized for low standby configurations
What I need from you:
1. Your specific sensor list (e.g., mmWave module names, temperature part numbers).
2. The maximum enclosure boundary dimensions you intend to fit the project into.
Note: This service covers technical graphics and trace layout drafting based on supplied documents. It does not include logic code building or sensory calibration.
Message me with your sensor list today to map out your consolidated layout!
Other Electronics Engineering Services I Offer
FAQ
Can you match the circuit mounting holes to fit a specific 3D-printed enclosure?
Yes. If you upload your exact mechanical dimensional requirements or an enclosure diagram, I will place the mounting holes and board boundaries to match those parameters precisely.
Do you handle the micro-amp deep sleep wiring trace layouts properly?
I trace out your power lines and pull-up resistor traces exactly as outlined in your component chip manual notes to allow for clean low-power standby configurations.
Can you help rearrange a messy sensor project I already started in KiCad?
Yes, absolutely. Send over your active project database folder and I will reorganize the trace routes, fix overlapping component paths, and clean up the layer hierarchy.
