Browse categories
Explore
Fiverr Pro
English
$
USD
I will design custom pcb for your raspberry pi project and pcb layout for manufacturing
Expert PCB Design, Reverse Engineering and Embedded Hardware
Transforming concepts into tangible electronics. I specialize in PCB design, reverse engineering, Raspberry Pi, schematic development, and ESP32 integration. Expect meticulously crafted, reliable solu...
About this Gig
Are you building a product or prototype around the Raspberry Pi (Standard, CM4, or CM5) and need a reliable, production ready PCB designed by an expert? You're in the right place.
I design custom PCBs specifically tailored for Raspberry Pi integration from simple breakout boards to complex carrier boards with power management, high speed signals, and multi layer stackups.
What I deliver:
- Complete schematic design (ERC verified)
- PCB layout with DRC clean files
- Gerber + drill files ready for JLCPCB / PCBWay / OSH Park
- Bill of Materials (BOM) with LCSC/Mouser part numbers
- 3D render of your board (STEP file on request)
- Design review PDF explaining all design choices
My expertise covers:
- Raspberry Pi 3/4/5 HATs (40-pin GPIO conformant)
- CM4 / CM5 carrier boards (PCIe, DSI, CSI, USB 3.0)
- Custom power regulation (LDO, buck, battery charging)
- Sensor interfaces: I2C, SPI, UART, CAN, RS485
- High speed differential pairs (USB, MIPI, HDMI)
- RF / antenna integration and layout best practices
Deliverables are sent in native project files (KiCad/Altium) + all standard export formats.
Message me before ordering to discuss your requirements, I'm happy to confirm scope and timeline upfront.
My Portfolio
FAQ
What files will I receive?
You'll receive Gerber + drill files for fabrication, a complete BOM with part numbers, schematic PDF, and the native EDA project files (KiCad or Altium).
Which Raspberry Pi models do you support?
All current models, Raspberry Pi 3B+, 4B, 5, Compute Module 4 (CM4), and CM5, including their carrier board design guidelines.
Can you help if I already have a partial schematic?
Sure. Send me your existing work and I'll review, complete, and optimize it before moving to layout.
Will the board pass DRC and ERC checks?
Yes. I deliver only DRC/ERC-clean files. I also run manufacturer-specific DRC (JLCPCB, PCBWay) to ensure your board is fab-ready with no surprises.
