Browse categories
Explore
Fiverr Pro
English
$
USD
I will design custom pcb for guitar pedal effects
Turning Ideas Into Production Ready Electronics and Mechanical Products
I’m an Electronics & Mechanical Engineer specializing in PCB design, circuit design, embedded systems, firmware, IoT, ESP32, STM32, Arduino, Raspberry Pi, KiCad, Altium, and mechanical product design....
About this Gig
Are you building a guitar pedal, audio effect, mixer, or custom electronics project and need a PCB that is ready for fabrication? I can help turn your circuit into a clean, reliable, and assembly-ready PCB design.
I'm an Electronics Engineer specializing in:
- Guitar pedal PCB design
- Schematic & circuit design
- PCB layout
- Manufacturing files.
I can work with:
- Your existing schematic
- Reference circuit
- Clearly defined requirements and design the board around your enclosure, components, connectors, pots, switches, and assembly method.
What I can provide:
- Guitar pedal & audio PCB design
- Schematic and PCB layout
- KiCad, Altium & EasyEDA
- Through-hole and SMD components
- Custom footprints and 3D models
- Single & double-layer PCB
- Gerber & drill files
- BOM/parts list
- Pick & Place/CPL files
- 3D STEP and PDF files
- DRC/ERC checks
- PCB redesign and modifications
I'll pay close attention to:
- Component placement
- Routing
- Board dimensions
- Clearances
- Connectors
- Your manufacturing requirements to help avoid costly fabrication issues.
Send:
- Schematic
- Reference design
- Pedal enclosure dimensions
- Project requirements before ordering, and let's get your PCB ready for production.
NOTE: Contact me first.
FAQ
Can you design a PCB for my guitar pedal circuit?
Yes. I can design PCBs for guitar effects pedals, audio effects, distortion, fuzz, overdrive, delay, reverb, mixers, preamps, and other custom audio electronics.
What do you need to start my pedal PCB design?
Ideally, send your schematic, circuit diagram, component list, enclosure dimensions, and any requirements for pots, switches, jacks, LEDs, connectors, or mounting holes.
Can you design the PCB from an existing schematic?
Yes. I can convert your existing schematic into a properly organized PCB layout and prepare the required manufacturing files.
Do you support both SMD and through-hole components?
Yes. I can design using SMD, through-hole, or a combination of both depending on your circuit and assembly requirements.
Can you design the PCB to fit my pedal enclosure?
Yes. Provide the enclosure dimensions, mounting-hole locations, component positions, and other mechanical constraints so the PCB can be designed accordingly.
Which PCB software do you use?
I work with KiCad, Altium Designer, and EasyEDA, depending on your project and preferred source-file format.
Will I receive Gerber and manufacturing files?
Yes, deliverables can include Gerber, drill, BOM, Pick & Place/CPL, PDF, 3D STEP, and editable source files.
Can you create custom footprints for pedal components?
Yes. I can create custom footprints and schematic symbols when the required components are not available in the standard libraries.
Can you modify or improve an existing pedal PCB?
Yes. I can review and modify an existing PCB design, including component placement, routing, dimensions, footprints, and other required changes.
Can you make the pedal PCB ready for fabrication and assembly?
Yes. I can prepare production files and perform relevant DRC/ERC checks while considering board dimensions, clearances, component placement, and your manufacturer's requirements.
