I will fix drone pcb issues, rf interference, overheating, unstable flight, esc, gps

I specialize in diagnosing and fixing drone PCB issues by optimizing RF routing, improving power integrity, reducing EMI noise, stabilizing ESC current flow, and correcting sensor placement for accurate flight performance.

Whether your drone is FPV, autonomous UAV, or ESP32-based flight controller, I will optimize your PCB design for stable flight, clean telemetry, and reliable hardware performance.

SERVICES

• Drone PCB issue diagnosis and troubleshooting
• RF interference elimination and noise reduction
• ESC overheating and power failure fixes
• Unstable flight controller debugging and repair
• ESP32 reset, brown-out, and stability fixes
• GPS drift correction and signal stabilization
• IMU sensor noise reduction and calibration support
• RF telemetry signal optimization and range improvement
• FPV signal loss and weak transmission fixes
• 50Ω impedance RF trace design and correction
• High-current ESC and motor power routing design
• Power distribution network (PDN) optimization
• Ground plane redesign and grounding isolation techniques
• EMI/EMC noise reduction and shielding layout
• 4-layer PCB stack-up design (Signal-GND-Power-Signal)
• Schematic design and circuit development

Kindly Contact me now