Browse categories
English
$
USD
Connect to your AI
I will design esp32 pcb, iot sensor, wifi and ble board, motor control layout pcb
Printed Circuit Board Designer
I'm Jacob Peterson, a PCB designer who helps makers, DIY starters and startups turn ideas into working hardware. I design ESP32, ESP8266, STM32 and Arduino boards using any PCB design software, from s...
About this Gig
About My Gig:
Your ESP32 works on the breadboard, then resets, drops WiFi or loses BLE range on the custom PCB? That is almost always layout: weak power rails, a blocked antenna or motor noise. I design ESP32 IoT sensor, WiFi, BLE and motor control boards with clean power, strapping pin checks and antenna clearance, so your first prototype boots, connects and runs stable.
SERVICES I OFFER:
- esp32 pcb design
- esp32 iot pcb
- esp32 custom board
- esp32 sensor pcb
- esp32 s3 pcb
- esp32 wifi pcb
- esp32 ble pcb
- esp32 motor driver
- esp32 solar pcb
- esp32 bms pcb
- esp32 relay board
- usb c esp32 pcb
- motor control pcb
- low power IoT PCB
WHAT YOU WILL GET:
- Manufacturing ready PCB layout
- Gerber, drill, BOM and pick and place files
- Antenna keep out and RF placement check
- Brownout safe power rail layout
- Auto reset and boot circuit with strapping pin check
- Motor noise isolation and back EMF protection
WHY WORK WITH ME:
- Pin and power plan checked before layout starts
- Clear notes on every pin choice
- Fast replies and clear communication
ARE YOU READY TO START?
Send me your sensors, motor or load, voltage, and board size, and message me before ordering. Let us build an ESP32 board that works the first time.
FAQ
What files will I receive at delivery?
You get manufacturing ready files including Gerber, drill, BOM and pick and place files, so you can send them straight to any PCB fabrication house.
Which ESP32 chips and modules can you design for?
I design boards for ESP32, ESP32 S3 and ESP32 C3 modules and chips. Tell me which one you want, or describe your project and I will help you pick the right one.
Will my board have stable WiFi and Bluetooth range?
That is my focus on every layout. I keep the antenna area clear of copper and metal, place the module correctly and keep noisy parts away from the RF section, so your signal stays strong.
Can you add motor drivers, relays or solar and battery power to my ESP32 board?
Yes. I lay out motor drivers, relays, battery charging and solar input with noise isolation and back EMF protection, so the motor or load does not reset your ESP32.
Should I message you before placing an order?
Yes, please. A quick message with your sensors, motor or load, voltage and board size helps me recommend the right package and give you an accurate delivery time
