Browse categories
English
$
USD
Connect to your AI
I will design pcb emi emc filtering, grounding and esd protection
PCB Design Engineer, Automotive ECU, RF, HighSpeed and Power Electronics
I’m a PCB Design Engineer specializing in automotive ECU, RF, high-speed, and power electronics. I create reliable, production-ready PCB designs tailored to your project requirements.
My expertise in...
About this Gig
Are you dealing with PCB noise, EMI issues, ESD sensitivity, or grounding problems?
I will design and optimize your PCB for EMI, EMC filtering, grounding, and ESD protection, helping improve noise control, signal reliability, and protection against electrical transients.
My services include:
- EMI/EMC filtering and noise reduction
- ESD and transient protection
- TVS diode protection
- Ferrite bead and common-mode choke filtering
- RC, LC and π filters
- PCB grounding and ground-plane optimization
- Ground stitching and return-path optimization
- Power-line filtering
- USB, CAN, Ethernet, RS-485 and other interface protection
- EMI/EMC-focused PCB layout improvements
I can work with new PCB designs or review and improve an existing schematic/layout. Depending on your project, I can provide updated PCB files, schematics, BOM, Gerbers and design recommendations.
I work with KiCad, Altium Designer, EasyEDA and other PCB design tools.
Send your schematic, PCB files, stack-up and project requirements, and I'll help develop a clean, practical EMI/EMC/ESD solution tailored to your board.
Lets improve your PCBs noise control, grounding and protection.
Other Electronics Engineering Services I Offer
FAQ
Can you add ESD protection to my existing PCB?
Yes. I can review your existing design and implement TVS diodes, transient protection, filtering, grounding, and optimized protection paths where required.
Can you design EMI filters?
Yes. I can design and integrate ferrite bead, RC, LC, π filters, and common-mode filtering for power and signal interfaces based on your application.
Can you work with USB, CAN and Ethernet boards?
Yes. I can design EMI/ESD protection and layout improvements for USB, CAN, CAN FD, Ethernet, RS-485, power inputs, and other external interfaces.
