I will design tinyml edge ai hardware pcb with esp32 s3 smart camera sensor interfaces
Pcb designer
About this Gig
Need hardware that runs AI on the device, not in the cloud? Edge AI products fail on power peaks, camera interfaces and heat more often than on the model.
I design edge AI PCBs for smart cameras, voice and sound sensing, robotics and industrial monitoring, from schematic to fabrication files.
Included:
- MCU class AI boards: ESP32-S3 or STM32 with PSRAM, flash, USB-C
- Camera, MEMS microphone and IMU interfaces
- Power design for inference peaks: Li-Po charging, regulators, load switches
- Wi-Fi/BLE antenna keep-out and layout
- Optional carrier boards for Raspberry Pi CM or Jetson modules using vendor reference designs
- Schematic and layout in KiCad or Altium
- Gerber, BOM, pick-and-place, PDF schematic, 3D STEP
This is hardware design. Model training, firmware and AI software are quoted separately.
Send your target MCU or module, camera and sensors, power source and enclosure size and I will confirm feasibility before you order.
FAQ
Do you design AI models or software?
No. I design the hardware: schematic, layout, power and interfaces. Model training and firmware are quoted separately.
Which platforms do you support?
ESP32-S3 and STM32 for MCU-class edge AI. Raspberry Pi Compute Module and Jetson carrier boards, and M.2 accelerator slots, are quoted after review.
Can you handle camera and microphone interfaces?
Yes. Parallel (DVP) camera interfaces and I2S or PDM MEMS microphones are standard. MIPI CSI camera routing is quoted by feasibility.
How do you handle power and heat?
I size regulators and load switches for inference peaks, add battery charging and protection, and note thermal limits. Final performance must be verified with your model running.
Which software do you use, and what files do I get?
KiCad or Altium, EasyEDA on request. You receive Gerbers, drill files, BOM, pick and place file, PDF schematic and a 3D STEP model.
Can you redesign my existing AI board?
Yes. Send your schematic, layout and issues (size, power, heat, cost). I review it and send a custom offer.
Can you design something custom, like a multi camera or high speed board?
Possibly. Send your requirements and I will confirm feasibility and send a custom offer before you order.
