I will design ph and ec conductivity probe interface pcb for water quality monitors
Embedded Firmware IoT Engineer ESP32 BLE LTE Flutter
About this Gig
Is your pH reading drifting or noisy, or jumping when a conductivity probe shares the tank? The cause is usually the analog front end, board leakage, or probe interaction.
I design pH and EC (conductivity) sensor interface PCBs for lab instruments, water-quality monitors, hydroponics and process systems.
Included:
- High impedance pH input: electrometer op-amp, guard ring, driven shield
- AC-excited EC measurement to avoid electrode polarization
- NTC or RTD temperature input
- 24-bit ADC with SPI or I2C to ESP32, STM32 or RP2040
- Optional isolation between probe channels
- Schematic and layout in KiCad or Altium
- Gerber, BOM, pick-and-place, PDF schematic
Accuracy depends on your probe, calibration and board cleanliness. You receive a design error budget, not a guarantee. Firmware and calibration software are quoted separately.
Send your probe model, measurement ranges and MCU and I will confirm feasibility before you order.
FAQ
Which probes and measurements do you support?
Glass electrode pH probes, two-electrode conductivity cells (cell constant agreed up front), and NTC or RTD temperature sensors. Four-electrode cells and ORP are handled by custom offer.
How do you prevent drift and noise on the pH channel?
An electrometer-grade op-amp, guard ring and driven shield, careful routing and cleaning guidance for low leakage. I explain the layout and assembly requirements in the delivery notes.
Why is isolation offered, and do I need it?
Probes sharing one liquid can disturb each other. Isolation between channels reduces that. Premium includes it; if you have one probe only, you may not need it.
Which MCUs, ADCs and software do you work with?
ESP32, STM32, RP2040 and nRF52 over SPI or I2C, with a 24-bit sigma-delta ADC. Layout in KiCad or Altium, EasyEDA on request.
What manufacturing files do I receive?
Gerbers, drill files, BOM, pick-and-place file and a PDF schematic.
Can you improve my existing pH or EC board?
Yes. Send your schematic, layout and symptoms. I review it and send a custom offer.
Can you guarantee a specific accuracy?
No. Accuracy depends on probe quality, calibration solutions, cable, temperature and assembly. I provide a design error budget and layout that supports good performance.
