I will design uhf rfid reader nfc pcb with rf layout and desfire module integration mhz
Pcb design
About this Gig
Is your RFID reader reading at 1 cm instead of 5? Range is decided by antenna, matching and layout long before firmware. I design RFID and NFC reader PCBs for access control, attendance, inventory, vending and industrial devices.
What I design:
schematic, component selection, reader IC integration (ST25R3916, PN5180, PN532 or MFRC522 class), PCB loop antenna layout, EMC filter and matching network with tuning pads, 13.56 MHz HF for ISO 14443, ISO 15693 and NFC, with ESP32 or STM32 control.
Reader specific engineering:
- antenna Q and bandwidth for the protocol data rate
- detuning from nearby metal and enclosures
- power and RF decoupling, ESD protection
- 4-layer layout around the reader IC
- DRC and DFM review.
What You receive:
schematic PDF, PCB layout, antenna and matching calculations, Gerbers, BOM, pick and place file, assembly drawing and tuning notes. Native source files come with higher packages.
Firmware, EMVCo or payment certification, regulatory testing and assembly are quoted separately.
Message me your frequency band, reader IC or module, read range, tag type and enclosure before ordering.
FAQ
Which frequencies and standards do you support?
HF at 13.56 MHz (ISO 14443 A/B, ISO 15693, NFC) is my core. LF 125 kHz is available as a custom quote. UHF (EPC Gen2) is offered through reader-module designs in Premium, with the regional band confirmed first
Which reader ICs and MCUs do you use?
ST25R3916, PN5180, PN532 and MFRC522 class parts, with ESP32, STM32 and other MCUs. Tell me your choice or I will recommend one for your protocol, range and budget.
Can you guarantee a read range?
No. Range depends on antenna size, field strength, tag type, enclosure and nearby metal. I design for your target and document the assumptions, and a tuning round on your prototype closes the gap.
Do you design the antenna, and how is it tuned?
Yes. I design the PCB loop antenna and matching network, then calculate starting values. Final tuning uses measurements from your prototype (VNA or scope data), which I analyze in the Standard tuning round.
Which CAD software do you use, and what files do I get?
KiCad, Altium Designer or EasyEDA. You receive Gerbers, drill files, BOM, pick-and-place, an assembly drawing and tuning notes, with native source files in Standard and Premium.
Can you fix an existing reader that has poor range?
Yes. Send the schematic, layout files and a description of the failure. I review the antenna, matching and layout first and quote a custom offer.
Do you do firmware, payment certification or large custom systems?
Bring-up firmware is an extra. Full firmware, EMVCo and payment certification, regional RF testing and assembly are quoted separately. Message me for complex or custom requirements.
