Browse categories
Explore
Fiverr Pro
English
$
USD
I will create professional pcb layout, schematic and manufacturing files
PCB Embedded Systems Engineer STM32, ESP32 IoT
I’m an Electrical & Electronics Engineer focused on PCB and embedded hardware development for IoT products, controllers, prototypes, and electronic devices. I work with STM32, ESP32, Arduino, sensors,...
About this Gig
Have a schematic, circuit or existing PCB that needs to become a clean manufacturing-ready board? I can create and refine your PCB layout with careful component placement, routing and design rule verification.
This service is suitable for prototypes, development boards, control electronics, IoT products and custom electronic devices.
You can receive:
- PCB layout from an existing schematic
- Component placement and footprint verification
- 2 layer, 4 layer and multilayer routing
- Power, ground and signal routing
- DRC/ERC checks
- Schematic review and corrections
- Gerber and drill files
- BOM and Pick & Place/CPL files
- Editable KiCad, Altium, EasyEDA or Eagle files
- 3D PCB view
- Manufacturing preparation and JLCPCB support
I can work from your schematic, PCB source, component list or project documentation. If you already have a board that needs routing, cleanup, correction or preparation for production, I can also work from the existing files.
Send the project details before ordering so I can review the scope and confirm the required deliverables.
Specialization:
Circuit design
•
Schematics
•
Layout
•
Analysis
File format:
Gerber
•
STEP
•
BRD
•
SCH
•
Software:
Altium Designer
•
EasyEDA
•
KiCad
Interface:
UART
•
USB
•
SPI
•
I2C
•
Wi-Fi
•
Ethernet
FAQ
Can you create a PCB from my schematic?
Yes. I can use your existing schematic and component information to create the PCB layout and prepare the required manufacturing files.
Do you provide Gerber and drill files?
Yes. Manufacturing outputs can include Gerbers and drill files, depending on the selected package.
Can you prepare files for JLCPCB?
Yes. I can prepare the required PCB manufacturing files and provide guidance for JLCPCB production.
Can you work with an existing PCB layout?
Yes. I can review, clean up, modify or complete an existing PCB project when the source files are available.
Which PCB software do you support?
I can work with KiCad, Altium Designer, EasyEDA and Eagle, depending on the project requirements.
