Browse categories
Explore
Fiverr Pro
English
$
USD
I will design rfid nfc pcb, access control and smart card hardware rfid hardware
PCB DESIGN
With a Master’s Degree in Electrical Engineering and nearly two decades in the automotive industry, I offer expert guidance in Arduino-based development, specializing in Espressif and RP2040/2350 cont...
About this Gig
Need a custom RFID or NFC PCB for your access control or smart card project?
I will design custom RFID/NFC electronics and embedded hardware for access readers, smart card systems, authentication devices, and contactless applications.
My services include:
- RFID and NFC reader PCB design
- 13.56 MHz NFC and HF RFID circuits
- 125 kHz LF RFID hardware, where required
- Antenna coil design and matching considerations
- Smart card reader and contactless interface circuits
- Door access controller and relay interface hardware
- MCU integration, USB, UART, SPI, I2C, and RS485
- Secure element and credential interface integration
- KiCad or Altium schematics, PCB layout, BOM, and Gerber files
Why work with me?
- Custom hardware for your requirements
- RF-aware PCB and antenna layout
- Manufacturing-focused documentation
- Clear communication and scope confirmation
Whether you're building an NFC reader, RFID access controller, or smart card prototype, share your specifications to discuss the right design.
FAQ
Can you design a custom RFID or NFC PCB from scratch?
Yes. I can develop the schematic and PCB layout around your selected reader IC, antenna, controller, and interface requirements.
Do you support 13.56 MHz NFC and 125 kHz RFID?
Yes, I can design for the appropriate frequency and technology based on the intended application and selected components.
Can you design a door access control PCB?
Yes. The hardware can include reader interfaces, MCU control, relay outputs, and communication interfaces as specified.
Can you integrate smart card readers?
Yes. Reader ICs and interfaces can be selected according to the required card technology, protocol, and security architecture.
. Can you design the RFID antenna?
I can help with antenna geometry, PCB layout, and matching-network design. Final read range and tuning should be verified through testing.
. Which PCB software do you use?
KiCad or Altium Designer can be used, depending on the project and agreed deliverables.
Will you provide manufacturing files?
Yes, when included in the selected package. Deliverables can include schematic and PCB source files, BOM, Gerbers, and DRC results.
