Browse categories
English
$
USD
Connect to your AI
I will design bldc controller pcb with mosfet and gate driver circuits
About this Gig
Hello and welcome!
I specialize in designing BLDC motor controller PCBs, MOSFET power stages and gate driver circuits for brushless motor applications. I help engineers, startups and product developers develop reliable motor control hardware tailored to their voltage, current and performance requirements.
WHAT I OFFER:
- Custom BLDC motor controller schematic and PCB design
- MOSFET power stage design and integration
- Gate driver circuit design and configuration
- Three phase inverter and ESC PCB development
- Current and voltage sensing circuits
- STM32 and microcontroller integration
- Power management and protection circuits
- Gerber, BOM and manufacturing files
WHY CHOOSE ME:
- Careful MOSFET and component selection
- Attention to switching paths and thermal design
- Hardware tailored to your motor specifications
- Clear communication and professional delivery
Whether you are developing a BLDC controller, custom ESC, robotics motor driver, or three-phase inverter, I can help with the electronic hardware design.
Share your motor specifications, operating voltage, continuous and peak current, preferred gate driver, MCU and required deliverables.
FAQ
Can you design a complete BLDC motor controller PCB?
Yes. I can develop the schematic and PCB layout, including MOSFETs, gate drivers, sensing circuits and MCU interfaces.
Can you design a three phase MOSFET inverter?
Yes. I can design three phase inverter hardware using suitable MOSFETs, gate drivers and supporting protection circuits.
Do you support different gate driver ICs?
Yes. I can work with suitable half-bridge and three-phase gate driver ICs based on your voltage, current, and switching requirements.
Can you integrate STM32 into the controller?
Yes. I can integrate STM32 microcontrollers and the necessary interfaces for motor control applications.
Can you design FOC motor controller hardware?
Yes. I can design the supporting hardware for FOC, including inverter stages, current sensing, gate drivers, and MCU interfaces. FOC firmware and tuning are separate unless included in the project scope.
Will I receive manufacturing files?
Yes. Depending on your package, I can provide Gerber, BOM, drill files, schematic and editable PCB project files.
Do you test the finished controller?
Simulation, prototype testing, and motor validation can be discussed as separate project requirements. PCB design alone does not guarantee tested motor performance.
