I will design altium 4 layer pcb, rf rader, sensor and embedded electronics

Reliable embedded hardware starts with a PCB architecture that accommodates electrical performance, component density and manufacturing constraints. RF paths, sensor connections and power distribution must be coordinated throughout the layout.

I develop 4-layer PCBs in Altium Designer for RF electronics, radar sensors, embedded controllers and connected hardware. My workflow prioritizes structured component placement, appropriate stackup planning, controlled-impedance requirements and clean routing for practical fabrication.

What I offer

• Altium schematic review and PCB layout
• 4 layer and multilayer PCB design
• RF transceiver and radar sensor integration
• Controlled-impedance routing planning
• High-speed differential-pair routing
• Ground-plane and power distribution design
• MCU, sensor and communication interfaces
• DRC checks and manufacturing preparation

What you will receive

• Editable Altium project files
• Gerber and drill files
• BOM and pick and place files when required
• Design rule check results
• Manufacturing documentation

Message me with your schematic, component datasheets, layer requirements and interface specifications to define the right scope for your hardware project.