Browse categories
Explore
Fiverr Pro
English
$
USD
I will design drone esc pcb power distribution bec uav high current layout
STM32 UAV PCB and Firmware Engineer for Drones and Robotics
I design high performance PCB and embedded systems for drones robotics and autonomous platforms. My work includes STM32 flight controllers ESC power systems CAN peripherals and sensor fusion boards. I...
About this Gig
Need a professional drone ESC PCB, 4 in 1 ESC, UAV power board, power distribution PCB, or BEC circuit for your drone project?
I design reliable high current drone electronics for FPV drones, quadcopters, VTOL UAV systems, robotics, RC aircraft, and custom aerial platforms.
My service focuses on what most sellers miss:
- High current copper routing
- MOSFET thermal management
- Low noise switching layout
- Compact lightweight PCB design
- Clean grounding strategy
- Battery input filtering
- Stable BEC 5V / 12V rails
- Efficient motor driver layout
- EMI conscious routing
- Manufacturing ready Gerber files
I can develop:
- 4 in 1 ESC PCB
- Single ESC board
- Drone Power Distribution Board (PDB)
- UAV BEC power module
- BLDC motor controller PCB
- LiPo battery power board
- STM32 / ESP32 control integration
- Sensor / telemetry power interface
Files Delivered:
- Schematic
- PCB Layout
- Gerber
- BOM
- Pick and Place
- 3D PCB Model
- Source Files
Perfect for startups, drone builders, hobby FPV pilots, robotics teams, and commercial UAV developers.
If you need compact, efficient, heat-safe and production ready drone power electronics, message me before ordering.
kindly contact me before ordering!!
FAQ
Can you design a 4 in 1 ESC PCB for FPV drone?
Yes. I design custom 4 in 1 ESC PCB boards for FPV drones, racing drones, quadcopters, and UAV platforms with compact layouts and thermal focus.
Can you make high current drone power boards?
Yes. I design high current PCB layouts with wide copper pours, via stitching, thermal paths, and safe battery routing.
Do you provide BEC power circuits?
Yes. I can integrate 5V, 9V, 12V BEC regulators for flight controller, camera, VTX, GPS, and payload systems.
Which software do you use?
I work with Altium Designer, KiCad, EasyEDA and other professional PCB tools.
Do you provide manufacturing files?
Yes. You receive Gerber, BOM, Pick and Place, source files, and production-ready outputs for PCB fabrication.
Can you help reduce ESC overheating?
Yes. I optimize MOSFET placement, copper thickness planning, airflow zones, switching loop layout, and heat dissipation.
