Browse categories
Explore
Fiverr Pro
English
$
USD
I will design stm32 pcb with rf transceiver, sensors and communication
PCB Designer and Firmware Development
I am an Electronics Engineer and Embedded Systems Expert specializing in radar safety PCB design, mmWave radar integration, proximity detection, and embedded firmware development. I design custom PCBs...
About this Gig
Need a reliable STM32-based board with RF and sensors that works on the first prototype? I design clean, manufacturable PCBs for embedded products.
WHAT I DESIGN:
- STM32 (F0/F1/F3/F4/G0/G4/L4/H7) core circuits
- RF transceivers (sub-GHz, 2.4 GHz, LoRa, nRF, CC series, SX12xx)
- Sensors (IMU, temperature, pressure, gas, ADC front-ends)
- Embedded communication: UART, SPI, I2C, CAN, USB, RS485, Ethernet
WHAT YOU GET:
- Schematic design or schematic review
- 2 to 6 layer PCB layout
- Proper decoupling, grounding and crystal placement
- RF trace routing with controlled impedance
- Gerber, drill, BOM and pick-and-place files
- DFM check for manufacturers like JLCPCB, PCBWay and others
- Source files in Altium, KiCad or Eagle (your choice)
WHY ORDER FROM ME
- Layouts built for EMC, signal integrity and low noise
- Fast communication andclear revisions
Send me your schematic, block diagram or requirements and I will recommend the best layer count and approach. Message me before ordering for custom or complex projects.
FAQ
Can you design the schematic too or only the layout?
Both. I can create the schematic from your requirements or just layout your existing schematic.
Which software and file formats do you deliver?
I work in Altium, KiCad and Eagle. You receive source files plus Gerber, drill, BOM
