Browse categories
Explore
Fiverr Pro
English
$
USD
I will do multilayer pcb layout routing from schematic gerber files kicad altium
Professional PCB Designer and Electronics Hardware Engineer
I am Philipp Humm, a professional Electronics Engineer specializing in production-ready PCB design, schematic capture, and hardware prototyping. I transform your concepts, sketches, or block diagrams ...
About this Gig
ALREADY HAVE YOUR SCHEMATIC? I WILL TURN IT INTO A CLEAN, PRODUCTION-READY PCB LAYOUT.
Send me your schematic and I deliver a professionally routed PCB layout with Gerber files ready to upload directly to JLCPCB, PCBWay, or any fab house no back and forth, no delays.
I specialise in PCB layout and routing using KiCad and Altium Designer:
- 2-layer and multilayer PCB layout from schematic
- Optimised component placement for signal flow
- Manual routing no autorouter shortcuts
- Differential pair routing and impedance matching
- Power and ground plane setup
- Via stitching and EMI shielding
- DRC check zero errors guaranteed
- DFM check manufacturable at any fab house
- Full Gerber file set production ready
- 3D board renders
- KiCad or Altium source files
Boards I regularly layout: Arduino, ESP32, STM32, FPGA, Raspberry Pi, RF, IoT, USB, HDMI, and industrial control boards.
MESSAGE ME BEFORE ORDERING share your schematic and I will confirm the right package and timeline.
Specialization:
Layout
•
Gerber
File format:
Gerber
•
SCH
Software:
Altium Designer
•
KiCad
•
Arduino
•
CircuitMaker
Interface:
HDMI
•
Wi-Fi
•
Ethernet
FAQ
Do I need to provide a schematic to get started?
Yes — this gig is for PCB layout from an existing schematic. If you need a schematic created from scratch, check my other gig which covers the full PCB process.
What format should I send my schematic in?
PDF, image, or native project files (KiCad .kicad_sch, Altium .SchDoc, Eagle .sch) all work. A clear photo of a hand-drawn schematic is fine too.
Do you use an autorouter?
No — every trace is manually routed for optimal signal integrity,
What is the difference between 2-layer and 4-layer?
2-layer has copper on top and bottom only — suitable for most simple boards. 4-layer adds internal power and ground planes, which improves signal integrity and reduces noise on complex boards.
Will the Gerber files work at JLCPCB or PCBWay?
Yes — all files are tested and formatted to upload directly to JLCPCB, PCBWay, and OSH Park without modification.
Can you handle high-speed signals like USB, HDMI, or DDR?
Yes — differential pair routing, impedance matching, and length tuning for high-speed signals is covered in the Premium package.
