Browse categories
Explore
Fiverr Pro
English
$
USD
I will design 13 56mhz rfid nfc pcb, antenna and embedded firmware
pcb design, embedded system and firmware development
I’m Ryan P an electronics engineer specializing in PCB design, embedded systems, and firmware development. I design reliable electronic solutions from schematic capture and PCB layout to MCU firmware,...
About this Gig
Hello and Welcome!
At 13.56MHz, an RFID/NFC PCB is not just a digital reader connected to a coil. The antenna, matching network, RF front end, PCB parasitics, grounding, and surrounding materials all interact as one resonant system. Small changes in coil geometry, trace width, capacitance, or component placement can shift resonance, reduce Q-factor, weaken coupling, and ultimately affect read range and reliability.
I can develop the electronics around your application requirements.
What I Will Provide:
- 13.56MHz RFID/NFC reader PCB design
- Custom NFC/RFID coil antenna design
- Antenna matching and tuning network
- Optimized coil geometry and PCB layout
- Component selection and RF-aware placement
- Embedded firmware for reader control and communication
- RFID/NFC protocol and reader configuration support
- Complete schematic and PCB layout
- Gerber, drill, BOM and manufacturing files
Why Choose Me?
- RF-aware PCB design beyond standard digital routing
- Antenna and matching designed as one RF system
- Hardware and embedded firmware in one workflow
- Clean, manufacturable and test-friendly PCB layouts
Message me today and let's design your RFID/NFC system from the RF layer up!!!
FAQ
What type of RFID/NFC PCB can you design?
I can design custom 13.56MHz RFID/NFC reader PCBs, HF RFID systems, custom antennas, reader interfaces, and complete hardware with embedded firmware.
Can you design the NFC/RFID antenna?
Yes. I can design the PCB coil antenna and its matching network based on the required operating conditions, PCB dimensions, tag type, and application.
Do you design the antenna matching circuit?
Yes. I can design the matching/tuning network and account for PCB parasitics, component tolerances, coil geometry, and resonance behavior.
Can you design the complete RFID reader?
Yes. I can integrate the RFID/NFC reader IC, antenna, matching network, MCU, power supply, communication interfaces, and supporting circuitry.
Can you work with an existing RFID/NFC IC?
Yes. You can provide your preferred IC or module, and I can design the surrounding RF, antenna, PCB, and firmware according to its datasheet requirements.
Can you develop the embedded firmware too?
Yes. I can develop firmware for reader initialization, configuration, communication, tag detection, data handling, and MCU peripheral integration.
