Browse categories
Explore
Fiverr Pro
English
$
USD
I will camera pcb layout, hdi pcb, bga routing and smt assembly ready design
PCB DESIGN AND FIRMWARE DEVELOPMENT
I am an Electronics Engineer and Embedded Systems Expert specializing in designing, developing, and optimizing intelligent hardware and firmware solutions. Experienced in microcontrollers, PCB design,...
About this Gig
A great camera board is not just about connecting componentsits about getting high-speed signals, tight BGA escape routing, HDI structures, and manufacturing constraints to work together without creating expensive surprises later.
What You Will Get
- Camera PCB layout tailored to your schematic and requirements
- HDI and BGA fanout/routing
- High-speed signal and power routing
- Clean component placement and stackup planning
- Manufacturing-focused checks for SMT production
What Makes Me Stand Out
I focus on the problems that can appear after fabricationnot simply making traces connect. I consider signal integrity, spacing, manufacturability, thermal paths, and assembly requirements throughout the layout process.
Deliverables
Gerber files, drill files, BOM/position files where required, source PCB files, and manufacturing-ready outputs.
Have a challenging camera PCB? Send your schematic and requirements, and lets turn them into a board ready for the next stage.
FAQ
Can you handle BGA routing on camera PCBs?
Yes. I can handle BGA fanout and routing while considering layer count, spacing, via structures, and manufacturing constraints.
Can you work with HDI PCB requirements?
Yes. I can work with HDI structures such as microvias, via-in-pad, and high-density component routing based on your manufacturer’s capabilities.
Can you route high-speed camera interfaces?
Yes. I can route interfaces such as MIPI CSI-2 and other high-speed connections according to the provided specifications and stackup requirements.
Will the PCB files be ready for SMT manufacturing?
Yes. I can prepare manufacturing and assembly outputs such as Gerbers, drill files, BOM, and pick-and-place files when required.
What do you need to start the project?
Please provide your schematic, component/BOM files, board dimensions, stackup requirements, manufacturer capabilities, and any specific routing constraints.
