I will design and simulate analog circuits and filters

Need an analog circuit that works on paper and in real life? Im Rajab, an electrical engineer with 7+ years of experience. I design and simulate analog circuits in LTspice so you can verify performance before spending money on hardware.

WHAT I DESIGN:

1. Amplifier Design Op-Amp, BJT, MOSFET-based amplifiers
2. Active & Passive Filter Design Low-pass, High-pass, 
3. Band-pass, Notch filters
4. DC-DC Converters Buck, Boost, Buck-Boost topologies
5. Voltage Regulators & Power Supply circuits
6. Oscillator & Signal Generator circuits
7. Transient, AC, and DC operating point analysis
8. Frequency response & Bode plot generation
9. Circuit troubleshooting & optimization

EVERY ORDER INCLUDES:

• Clean, labeled LTspice schematic (.asc)
• Transient, AC and DC operating-point results
• Bode plots and key performance numbers
• Short PDF report explaining design choices and component values

Recent work: a nine-stage active bandpass filter bank covering 1 mHz to 25 Hz using chopper-stabilized op-amps.

To start, send your target specs (gain, bandwidth, supply voltage, load) or a rough sketch. No specs yet? Tell me what the circuit should do and Ill help define them.

I reply within a moment