I will do civil and structural engineering, structural design, analysis, framing plans

I normally need the architectural plans, dimensions, number of floors, intended use, structural material, site/location information, and any available geotechnical or existing condition data. These details affect the structural system, loading assumptions, foundation approach, and overall design.

Yes. I can review the architectural layout and develop an appropriate framing concept around the building geometry, spans, openings, load paths, and structural constraints. The objective is to maintain a practical load path from the supported elements through beams, columns or walls.

A soil report is important because bearing capacity, settlement, groundwater, and soil conditions can materially affect foundation selection. If geotechnical information is unavailable, I can identify the required assumptions and limitations before proceeding.

Yes, subject to the information available. I can review the relevant geometry, loads, spans, support conditions, material properties, and existing drawings to perform the agreed structural checks and identify areas requiring modification or further investigation.

The analysis depends on the project scope, but may involve applicable dead, live, environmental and other project specific loads, load combinations, reactions, member forces, and design checks.

Yes. Structural layouts need to work with the architectural design rather than exist independently. I can coordinate framing, columns, beams, slabs, openings and other structural elements against the architectural layout to identify conflicts and maintain a practical construction arrangement.

I can prepare organized structural documentation according to the agreed scope, including foundation plans, framing plans, structural details and calculations where included. For permit or construction use, the applicable local code and jurisdictional requirements.