Browse categories
Explore
Fiverr Pro
English
$
USD
I will do pcb design on rf and high speed multilayer pcb layout with fab ready files
About this Gig
Looking for a reliable partner to design your automotive ECU or control board? I deliver production-ready PCBs with CAN bus in Altium Designer, from schematic to final Gerber files.
WHY CHOOSE ME
Automotive-focused design experience
EMC-aware routing and clean signal integrity
Clear communication and on-time delivery
Design check before every handover
WHAT I CAN DO
- ECU, BCM, gateway and telematics boards
- Sensor, actuator and EV electronics
SERVICES I OFFER
- Schematic design and component selection
- CAN / CAN FD with termination and protection
- 2 to 8 layer PCB layout
- Reverse polarity, load dump and TVS protection
WHAT YOU WILL GET
- Gerber and drill files
- BOM and pick and place file
- Schematic PDF
- Native Altium files
READY TO START?
Message me with your project details before ordering and I will confirm your scope and timeline. Order now and let's turn your idea into a board that's ready for fabrication!
FAQ
Do you write firmware or assemble boards?
No, this gig covers PCB design only. I'm happy to make your files ready for any assembly house.
Do you provide ISO 26262 or AEC-Q certification?
No. I design the PCB following automotive best practices, but functional safety certification is outside this service
Can you work from my existing schematic or block diagram?
Yes. Send whatever you have, even a rough sketch or component list, and I'll confirm the scope before starting.
