I will convert your expresspcb file into gerber files you send to your pcb fabricator

For a Fiverr, I will convert your Single Layer ExpressPCB printed circuit board file into RS-274x Gerber files from V7.x or older ExpressPCB files.

These Gerber files are the files most used by PC Board Fabrication Houses around the world to make your design into printed circuit boards.

For a Double-layer PCB, add one Gig.

Send me your Single-Layer printed circuit board ExpressPCB file, and I will send you back a zipped file containing RS-274x Gerber Plots of

Top Silkscreen Layer,
Bottom Etch Layer,
Bottom Solder Stop Mask,
Board Outline file,  and
Excellon Drill Guide.

(Maximum 8"x10" PCB layout for this gig.)

See my other Gerber Conversion Gig if you need Double-Sided ExpressPCB conversion.

See my other Getting Started Gig if you would like my White Paper on my Overseas Short and Long run PCB Fabrication houses.

Are you ready to get your design into production?  THEN LET'S GET STARTED...

DISCLAIMER: By using this service, you are agreeing that you own the rights to the PCB board design that you provide, or have the authority by the owner of the design to have conversions made of the provided design.