Browse categories
English
$
USD
Connect to your AI
I will develop custom esp32 stm32 embedded
About this Gig
About the gig!!
I specialize in custom ESP32, STM32, and microcontroller based embedded electronics PCB development. My focus is on clean routing, organized component placement, design rule compliance, and practical hardware implementation to help you move your project toward prototyping.
My Services
- Custom ESP32 PCB Layout
- STM32 Microcontroller PCB Design
- Embedded Electronics PCB Development
- Circuit Schematic Capture
- 2-Layer, 4-Layer, and Multilayer PCB Layout
- IoT and Sensor Controller Boards
- UART, SPI, I²C, CAN, USB, and RS485 Interfaces
- Power Management and Battery Circuits
- Component Selection and Footprint Creation
- PCB Redesign and Circuit Modification
- DRC/ERC Verification
- 3D PCB Visualization
What You Will Receive
- Altium Designer source project
- PCB layout and schematic files
- Gerber and drill files
- Bill of Materials (BOM)
- Pick & Place files, where applicable
- 3D PCB model, depending on your package
Why Choose My Service?
- ESP32 and STM32 embedded hardware solutions
- Manufacturing focused documentation
- Careful component placement and routing
- Project specific engineering approach
- Clear communication and attention to detail
message me before placing an order.
FAQ
Can you design custom ESP32 and STM32 PCBs?
Yes, I can develop custom PCB layouts for ESP32, STM32, and other microcontroller-based embedded electronics projects.
Which software do you use for PCB design?
I use Altium Designer for schematic capture, PCB layout, component placement, routing, and manufacturing documentation.
Can you design multilayer PCBs?
Yes, I can design 2-layer, 4-layer, 6-layer, and 8-layer PCB layouts according to your project requirements.
Do you support communication interfaces?
Yes, I can integrate UART, SPI, I²C, CAN, USB, RS485, and other interfaces based on your circuit specifications.
What files will I receive?
Depending on your package, you can receive Altium source files, schematic files, Gerber files, drill files, BOM, Pick & Place files, and 3D PCB visualization.
Can you design IoT and sensor interface boards?
Yes, I can develop custom IoT PCBs, sensor interface boards, embedded controllers, and microcontroller based hardware.
Will my PCB be ready for manufacturing?
I will prepare fabrication documentation and perform design rule checks. Final manufacturing compatibility depends on your PCB manufacturer's specifications.
Do you provide firmware programming?
Firmware development is not included in the standard packages. It can be discussed separately if required.
