I will power system study in etap and digsilent powerfactory

WHAT I OFFER

Load Flow Analysis

Steady-state power flow under normal and N-1 contingency conditions

Voltage profile assessment at all network buses

Active and reactive power balance verification

Reactive power compensation sizing (capacitor banks, reactors)

Multiple loading scenarios (peak, off-peak, minimum generation)

Short Circuit Analysis

Three-phase (3LG), single line-to-ground (SLG), line-to-line (LL) faults

Maximum and minimum fault current at all buses and POI

Switchgear and circuit breaker rating verification (IEC 60909 / IEEE C37)

Fault contribution from generators, motors, and grid sources

DC offset and X/R ratio assessment

Protection Coordination Study

Relay coordination and time-current curve (TCC) grading

Overcurrent, earth fault, and differential protection settings

Relay pick-up, time dial, and instantaneous element setting

Protection device selectivity and discrimination

Relay setting schedules ready for site implementation

Arc Flash Hazard Analysis

Arc flash incident energy calculation at all switchgear and MCC panels

Incident energy levels (cal/cm²) and arc flash boundary distances

Personal protective equipment (PPE) category assignment

Hazard labels