I will design a precision ph meter circuit uart and conductivity sensor interface pcb
pcb design
About this Gig
I will design a precision pH and conductivity sensor interface PCB for water quality monitoring, laboratory instruments, hydroponics, aquaculture, and industrial measurement systems.
What I can design:
- pH electrode interface and high-impedance analog front end
- Electrical conductivity (EC) measurement circuits
- Low-noise signal conditioning and suitable amplifier stages
- ADC and microcontroller interfaces for ESP32, STM32, Arduino, or your preferred platform
- Temperature sensor inputs for conductivity compensation
- Analog output, I2C, SPI, UART, or other required interfaces
- Power regulation, grounding, filtering, and input protection
- Custom schematic capture and PCB layout
What you will receive:
- Circuit schematic and PCB layout
- Component selection and bill of materials (BOM)
- Gerber and drill files
- Editable design files according to your package
I focus on practical circuit design, careful high-impedance routing, noise reduction, and clear manufacturing documentation tailored to your application.
Please message me before placing an order so we can confirm your requirements
FAQ
Can you design both pH and conductivity measurement circuits?
Yes. I can design either interface separately or combine both on one PCB, depending on your requirements and budget.
Can you design a low-noise pH sensor interface?
Yes. I can focus on high-input-impedance circuitry, leakage reduction, careful grounding, and noise-conscious PCB layout. Actual performance depends on the probe, components, layout, and calibration.
Can the PCB work with ESP32, STM32, or Arduino?
Yes. I can design suitable analog outputs or digital interfaces for your chosen controller, subject to the required voltage levels and measurement architecture.
Can you include temperature compensation?
Yes. I can add a temperature-sensor interface and design the required signal path. The compensation method and implementation requirements should be agreed before ordering.
Can you design a combined pH, EC, and TDS monitoring PCB?
Yes. A combined design is possible. TDS estimation typically uses conductivity and an application-dependent conversion factor.
Will you provide Gerber files and a BOM?
Yes. These can be included according to the package you select, along with the specified schematic and editable design files.
Does the order include firmware, calibration, and physical testing?
Not by default. Firmware, prototype testing, probe calibration, and verified accuracy can be discussed and quoted separately.
