I will design your pcb layout and schematic for manufacturing

Manufacturing-ready PCB design: schematic, layout, Gerbers, BOM, CPL and 3D STEP. Files tuned for JLCPCB.

I design PCBs in EasyEDA and Altium Designer, from a rough idea all the way to fabrication files your board house accepts without a single back-and-forth. Every design runs through ERC and DRC, and the BOM is cross-checked against what your fab actually stocks, so you do not get a "part discontinued" surprise after paying.

What you receive:

- Schematic (PDF plus editable source file)

- Gerber X2 and NC drill files

- BOM in CSV, with LCSC or DigiKey part numbers

- Pick-and-place (CPL) file for SMT assembly

- 3D STEP model to check fit inside your enclosure

- DFM notes before you order

I am based in jiangsu, and that matters. I work inside the JLCPCB and LCSC ecosystem daily, so I know which footprints, panel sizes and tolerances cost you nothing, and which ones trigger an engineering-query email and a two-day delay. Most designers hand over Gerbers and leave you alone with the ordering screen. I do not.

Message me before ordering with your requirements, key parts and board size. If it is not a good fit, I will tell you straight.