Browse categories
Explore
Fiverr Pro
English
$
USD
I will create manufacture ready pcb gerber, bom and cad drawings
About this Gig
An email from your fab house flagging a drill size violation or a missing solder mask clearance rarely comes at a good time, usually it lands right after you thought the design was locked and your production slot was booked. I've spent enough time on the review side of that process to know exactly what a fabrication engineer checks before a board goes to panel, and I run that same review on your files before they ever leave my hands.
What I Bring to Your Project:
- Full DFM & DFA compliance review
- RS-274X gerber & Excellon drill file generation
- BOM verification against manufacturer part numbers
- Pick-and-place file creation for assembly
- Dimensioned fabrication & assembly drawings
- IPC Class 2/3 standard verification
- Layer stack-up & impedance cross-check
- JLCPCB, PCBWay & Sunstone-specific formatting
- Native file cleanup Altium, KiCad, Eagle
- A written report of every issue found and fixed
Send me your current files and target fabricator I'll tell you plainly whether they're ready or what's standing in the way.
My Portfolio
Other Electronics Engineering Services I Offer
FAQ
What exactly is a "DFM check"?
A review of your design against manufacturing rules, trace width, clearance, drill size to prevent fabrication failures.
Can you work from a design that's not in Altium?
Yes, I accept KiCad, Eagle, EasyEDA, and OrCAD files, plus raw Gerbers for review.
Do you generate pick-and-place files?
Yes, included in Standard and Premium for assembly-ready output.
Will these files work with JLCPCB/PCBWay?
Yes, files are formatted to each fabricator's specific submission requirements.
What if my design has errors?
I flag every issue found in a DFM report and fix what's within scope before delivery.
Can you match IPC Class 2 or Class 3 standards?
Yes, I can verify designs against the IPC class you specify.
